RIDEX 2232W0101 Tyre pressure sensor (TPMS) with groove, with valves

www.autodoc.co.uk: Dear customer,
Thank you for your question.
According to the provided VIN code JTHKD5BH702XXXXXX, Tyre pressure sensor (TPMS) 2232W0101 RIDEX is not suitable for your vehicle.
Please, check the compatible option by the link:
OEN 4260730071 the Article : 70699443 HERTH+BUSS ELPARTS https://www.autodoc.co.uk/lnk-25408997
Feel free to contact us by chat.
Best regards,
the autodoc.co.uk team

www.autodoc.co.uk: Dear customer,
Thank you for your question.
According to the provided VIN/Chassis number VF1RZG00059XXXXXX, the requested Tyre pressure sensor (TPMS) 2232W0101 RIDEX is compatible with your vehicle (OEN: 407004CB0B).
Feel free to contact us by chat.
Best regards,
the autodoc.co.uk team

www.autodoc.co.uk: Dear customer,
Thank you for your question.

According to the provided VIN/Chassis number W0LPD9E30F2******, the requested Tyre pressure sensor (TPMS) 2232W0101 RIDEX is compatible with your vehicle. OEN is 13581560.

Please, note that it needs programming.

The sensors are linked automatically during a test drive.
1. Install the sensor on the vehicle.
2. Inflate all tires to the pressure recommended by the vehicle manufacturer.
3. To link the sensors to the vehicle, it is necessary to carry out a test drive at a speed of at least 40 km/h for up to 20 minutes.
If the sensor in the spare wheel has been replaced, then it is linked to the vehicle using diagnostic equipment by entering the sensor identifier into the vehicle's on-board system (on some vehicles, the spare wheel sensor is linked automatically).
For some vehicles, before a test drive, the manufacturer recommends leaving the vehicle with the ignition on for 15-20 minutes without movement to recognize new sensors. This requirement is desirable, but not mandatory.
Or using IP608 XTOOL

Feel free to contact us by chat.
Best regards,
the autodoc.co.uk team